TJ to JK Axle Conversion 1-Ton Aluminum Tie Rod and Drag Link Steering Flip Kit

TJ to JK AXLE CONVERSION 1-TON ALUMINUM TIE ROD & DRAG LINK STEERING FLIP KIT

This kit is specifically designed to fit a JK axle under your TJ/LJ. The drag link uses the factory pitman arm. The factory JK tie rod is made from a hollow thin-wall tube. The problem with most aftermarket units is they are still made of steel which once bent will stay bent. Our tie rod and drag link are made with 1.5" SOLID 7075 aircraft aluminum. 7075 aluminum carries a memory to it. When it is bent, it pops back into place!

Never replace your tie rod again!!!

Features:
7075 center section with Limited Lifetime Warranty
Hexed ends for easy adjustment
Right and left hand threaded offset 1-ton tie rod ends for one-handed adjustment on toe settings
Greaseable 1-ton tie rod ends
Taper sleeve provided for easy install
Correct steering geometry after lifting 4" or more

PLEASE NOTE:
Clamp sold separately
AEV or stock Rubicon wheels require a 1.5" wheel spacer
17" wheel with a 4.75" backspacing or less required
Basic drilling required
4'' lift or higher recommended
Raised track bar bracket also recommended for best steering quality on the road